Skip to content
Brooklin Garage Door ServicesRequest a visit
Open 24/7(289) 278-1736Call now
Gloved person holding a black strip along the side of a sectional garage-door opening — Garage Door Perimeter Weatherstrip, Myrtle Station

Plan ahead Repairs · Myrtle Station

Garage Door Perimeter Weatherstrip in Myrtle Station

The bedroom over the garage is always the cold room, and standing in the garage you can feel why: a steady draft along the door edges that moves the cobwebs on the wall. The seal around the opening has flattened to nothing.

Call now · open 24/7(289) 278-1736

Request a visit

In plain words

The skill in this job is in the position of the fin. It should touch the door with a small, even deflection, so that it seals when the door is closed and springs clear as the door lifts. Set too far off, it leaves a standing gap; pushed too hard, it drags, folds under and tears within a season. The header piece goes on first, fastened from the centre outward so it stays straight, and the sides are fitted tight beneath it so the fins overlap at the corners. Fasteners are spaced evenly in sound wood, and any joint where water could get behind the stop is caulked.

Sound familiar?

The new door went in last year and looks perfect, but the old wooden stop and its tired seal were left in place. Along the top there is a gap you could slide a finger into, and the cold pours through it.

How the visit goes

Garage Door Perimeter Weatherstrip · Myrtle Station

How the visit goes

Dark wall-mounted box with a plug-in adapter and sensor beside a garage door, above a workbench with a drill and screws. — Myrtle Station
  1. 1

    What kind of seal is there now

    Openings carry different seals depending on their age and who last worked on them. Many older garages have a painted wood stop with a flexible vinyl fin nailed to its face. Newer installations often have a one-piece vinyl stop with the fin moulded in. Some commercial and premium doors use an aluminum retainer with a slide-in rubber insert, or a brush seal. The technician identifies which is present, whether the rigid part is sound enough to keep, and what the fastening was, because that decides whether a new fin goes onto the existing stop or the whole stop is replaced.

  2. 2

    Cycling the door and sealing the joints

    Once all three lengths are on, the door is run through several full cycles by hand and then with the opener, while the technician watches each fin for catching, folding or rubbing and listens for a squeal. The daylight test is repeated from inside with the lights off. Any joint between the new stop and the trim or brickmould where water could get behind is caulked with an exterior sealant, and the fin is wiped with a silicone spray to cut the odds of ice bonding it to the door. The old material is bagged and removed, and the household is walked round the finished opening.

  3. 3

    Before the freezing rain

    In late autumn, wipe the fin with a silicone spray or a silicone-based lubricant on a cloth. It leaves a film that cuts the odds of meltwater bonding the fin to the cold door face during an ice storm, though a hard freeze can still catch it. Oil-based products are avoided because they swell and soften vinyl over time. The same wipe once or twice through the winter keeps the fin supple. If the door does freeze to the seal, a little warm water along the edge from inside, or simply waiting for the sun, frees it without pulling; dry the thawed spot afterwards so it does not simply refreeze.

In the van

  • Silicone spray lubricant
  • Vinyl stop moulding with integral seal
  • Aluminum retainer and rubber insert
  • Galvanized or stainless trim nails
  • Exterior screws and weatherproof staples

What affects the quote

  1. 1

    Partial replacement

    Replacing one damaged length rather than all three is a smaller job, provided the remaining pieces are still soft and the profile can be matched.

  2. 2

    Commercial or oversized openings

    Wider and taller commercial doors often carry an aluminum retainer with a rubber insert or a brush seal, and the material and fitting time differ from a residential vinyl seal.

  3. 3

    Removing the old stop and paint build-up

    Lifting a wood stop that has been painted for decades, scraping old adhesive and knocking down paint ridges takes longer than pulling a loose fin, and the time shows in the quote.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 278-1736

Garage Door Perimeter Weatherstrip: questions

Advice · (289) 278-1736

What should I do before the technician arrives?

Move the car out of the garage or well back from the door, and clear anything stored against the jambs inside and any bins, planters or snow piled against them outside. Leave the door closed so the gaps can be seen as they are. If you have noticed where the daylight, drafts or snow come in, or where the mice appear, be ready to point it out.

The wood around my door is rotten near the floor. Can the seal still go on?

Yes, and the rot is handled first. The soft wood at the base of the jamb is cut back to sound material and a new piece of lumber or PVC trim is spliced in, fixed and primed, so the fasteners for the new stop bite into something solid. This is one of the most common additions to a perimeter seal job here, because slush and salt sit against the jamb base all winter.

Will replacing the perimeter seal keep mice out?

It closes one of their favourite routes. Mice enter at the open corners where the header and side seals meet and along a fin that has shrunk back from the door, so a continuous, overlapped seal removes those gaps. It works alongside a sound bottom seal, a swept threshold and attention to any other openings in the garage wall, and a technician will point out any of those noticed during the visit.

Garage Door Perimeter Weatherstrip near you

Durham, Ontario

Myrtle Station information

Town
Myrtle Station, Durham, Ontario
In business
30 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

25%

Newer homes. About 25% of homes in Whitby were built in 1980 or earlier, according to the 2021 Census.

Newer doors are built to tighter tolerances, so a small bend in a track or a loose bracket shows up sooner as a rub or a shudder. Regular tune-ups keep everything aligned and catch the wear on rollers and hinges before it affects the panels.

70%

Mostly houses. Single-detached houses make up about 70% of homes in Whitby (2021 Census).

Where homes are detached, the garage is frequently a workshop or storage room as well as parking, and the door may be opened dozens of times on a Saturday. Sealed-bearing rollers, protected sensors and a regular tune-up keep a hard-working door running smoothly.

Source: Statistics Canada, 2021 Census of Population

Open Myrtle Station in Google Maps

Open 24/7

Request a visit

The bedroom over the garage is always the cold room, and standing in the garage you can feel why: a steady draft along the door edges that moves the cobwebs on the wall.

Call now · open 24/7(289) 278-1736
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 30 years in business